Makita CRU03 Manual De Instrucciones página 12

3. Insert the plug of the tool into the socket of the
portable power pack.
When inserting, align the triangle marking on both the
plug and the socket.
1
► 1. Plug 2. Socket 3. Triangle marking
4. Adjust the cord length using the holder as
necessary.
1
► 1. Holder
The cord length is properly adjusted when you can;
— swing the tool without any hinderance by the cord;
— swing the tool without letting the cord flopping and;
— disconnect the plug from the socket without taking
off the shoulder harness of the portable power pack.
CAUTION:
Allow the cord to have a appro-
priate play between the tool and portable power
pack. If the play is too little, the tool movement may
be hindered. If the play is too much, the cord may be
caught by other object and result in accident.
Starting the operation
CAUTION:
the working position by following the instructions
in the section for the working position.
2
CAUTION:
the buckles on the waist belt is locked.
CAUTION:
ton to turn on the tool immediately before cutting
grass. Failure to do so may cause personal injury
due to unintentional start up.
1. Install the battery cartridge(s) to the portable
power pack.
3
1
► 1. Portable power pack 2. Battery cartridge
NOTE: Refer to the instruction manual of your
portable power pack for how to install the battery
cartridges.
2.
Press the power button on the portable power
pack. The main power lamp will light up.
► 1. Main power lamp 2. Power button
12 ENGLISH
Before operation, finish adjusting
Before operation, make sure that
Always press the main power but-
2
2
1