Rexel AUTO+750X Manual Del Usuario página 12

GB
self-cleaning cutters
After emptying and replacing a full bin, the shredder will run in forward for 4 seconds, stop for
2 seconds and then reverse for 4 seconds to clear away any remaining paper from the cutter
mechanism. This unique 'self-cleaning' mechanism is additional jam prevention technology
from Rexel.
8. comb bind removal hooks
Note – Use only on standard comb bind strips.
1 Open bin door.
2 Place document onto the comb bind hooks.
3 Pull down on the document to remove comb strip.
9. maintenance
The rollers on the auto-feed mechanism may become dirty over time, please wipe clean with a dry
cloth to maintain maximum product performance.
The auto-start infra-red sensor, located in the paper feed entry-slot, can occasionally become
covered in paper-dust causing the shredder to run despite no paper being fed into the machine.
Switch the shredder off at the rear of the machine and carefully clean the sensor using a cotton-
swab.
service
We recommend these machines are serviced every 6 to 12 months by a Rexel service engineer –
see back of this booklet for the contact details of your local service centre and for enquiries about
maintenance contracts.
shredder accessories
We recommend that a paper waste sack for
recycling shredded paper is used on all models.
* ACCO Brands Europe accepts no liability for product performance or safety when other types or brands of lubricants are used on
any part(s) of this machine.
12
register this product online at www.accobrands.com
Accessory Part Number
Recycling Waste 1765030EU
Sack
Plastic Waste 40060
Sack
Oil* Refill Bottle 1760049
Box Quantity
50
100
8