Reverse Function - Rexel AUTO+750X Manual Del Usuario

GB
2. operation
1 After unpacking the product pull out the shredder bag frame and remove the CD shard tray,
which sits on top of the bag frame. Store this tray on the product as shown and use when you
shred CDs.
2 Lift up the loading door and open oil flap.
3 Remove oil cap and fill up the reservoir using the 60ml bottle of oil provided. Replace the cap.
4 Connect the shredder to mains supply.
5 Check that the on/off switch at the back of the machine is switched to the 'ON' position.
6 Press and hold down the Auto button (
system. Only required when the product is used for the first time.
7 To load the shredder, simply lift the loading door handle to open the loading door and insert
documents. You can open the door further to 90 degrees for easier access if required Load up to
750 sheets at a time into the feed chamber.
Do not fill above the MAX level, this could damage the shredder.
8 The shredder will start the shredding cycle automatically ONLY after closing the loading door.
If there is paper in the Autofeed chamber after first attempt, open and re-close the paper loading
door a second time.
Attention: If required you can now lock the loading door by entering a 4 digit code (see Locking
the Paper Loading Door section).
9 If you only have up to 10/12 sheets to shred, you can use the manual feed slot, provided the
auto feed chamber is empty.
10 Insert paper to be shredded into the feed area. The shredder will detect the paper and start
automatically.
11 Intelligent Jam Clearance: If the shredder is left in auto mode for more than 2 minutes without
being used, the shredder will automatically turn back to sleep mode in order to save power.
12 The shredder will automatically 'wake up' from sleep mode when paper is inserted into the
shred mouth or you open the loading door. There is no need to press the Auto button (

3. reverse function

1 Should you wish to reverse paper out whilst shredding, a reverse button (
your convenience.
2 Reverse the paper out then turn the machine off using the ON/OFF switch at the rear of the
shredder. Remove the paper from the manual feed slot (if being used) or open the loading door,
remove the remaining stack of paper, then pull the jammed paper free of the cutting mechanism.
3 To resume shredding, turn the shredder on using the ON/OFF switch at the rear of the shredder.
Return the switch to the auto position (
10
register this product online at www.accobrands.com
) for 5 seconds to start the pump and prime the
).
).
) has been fitted for