Technical Specifications - VONROC CD508DC Traducción Del Manual Original

TECHNICAL SPECIFICATIONS

Model No.
Charger
Input of charger
Output of charger
Rechargeable battery pack
Battery charging time
Chuck capacity
Torque settings
No load speed
Weight
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h,D
(Drilling into metal)
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3.
1. Machine
2. Chuck
3. Torque adjustment ring
4. Direction switch
5. On / off switch
6. Work light
7. Charging socket
8. Charger adapter
9. Charger LED indicator
WWW.VONROC.COM
10. Bit holder
11. Screwdriver bit
CD508DC
3. OPERATION
CD817AA
110-240V, 50/60Hz, 12W
8.4V DC 1.0A
8 V Li-ion 1.3Ah
Charging the machine (Fig. B)
In order to charge the machine, insert the small
1.5-2 hours
plug of the charger adapter (8) into the charging
0.8 - 10 mm
socket (7) on the bottom of the machine.
10 + Drill mode
Subsequently plug the mains plug connector of
the charger adapter (8) into a socket outlet. The
0-550 /min
charger indication light (9) will show the charging
0.9 kg
progress.
74 dB(A), K=5dB(A)
LED indicator (9) (Fig. A)
85 dB(A), K=5dB(A)
The charger adapter has 1 LED indicator (9) which
K=1.5 m/s
3.51m/s
2 2
indicates the status of the charging process:
• Fully charging the battery may take up to 1.5-2
• After the battery is fully charged remove the
Fitting and removing drills or screwdriver bits (Fig. C)
The drill chuck (2) is suitable for drills and screwdriver
bits with round shaft as well as hexagonal shaft.
• Hold the machine firmly with one hand.
• Open the drill chuck (2) by rotating the chuck
• Insert the shaft of the drill or screwdriver bit.
• Tighten the drill chuck again by firmly rotating
• Check if the bit is centered well by shortly
The battery must be charged before first use.
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
hours.
charger adapter from the outlet.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Always remove the battery before mounting
an accessory.
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
the chuck (2) counterclockwise.
activating the machine´s on/off switch.
EN
7