GE GFD40 Manual Del Propietário página 15

INSTALLING THE STACK BRACKET KIT
INSTALL DRYER AND
5
BRACKET ON WASHER
Disconnect power before installing.
WARNING
Failure to do so could result in
serious injury or death.
WARNING
Failure to do so may result in back or other injury,
or property damage.
• Use two or more people to install dryer.
• Avoid tipping and rupture of utility services.
• Dryer must be securely attached to the washer.
• DO NOT place the washer on top of the dryer.
• Mobile Home or Manufactured Home Installation
– Stacking of a gas dryer is not permitted in a
mobile home or manufactured home.
A. Lift the dryer on top of the washer. Be careful not
to scratch the top of the washer with the brackets.
Protect the washer control panel with cardboard
or other protection. Be sure to lift the dryer high
enough to clear the washer control panel.
B. Align the holes in the bracket with the holes in the
back of the washer. Using a Phillips screwdriver,
attach the 2 #8 x 1/2" tapping screws. Repeat on
both sides of the washer.
Attach brackets to
back of washer
49-90584
Optional Instructions
- Excessive Weight
Hazard
FINALIZE THE INSTALLATION
6
Do not push on the dryer once
CAUTION
installed to top of the washer.
Pushing on the dryer may result in pinched fingers.
A. Refer to the washer Installation Instructions to
complete the washer installation.
B. Refer to the dryer Installation Instructions to
complete the dryer installation.
C. Carefully slide or walk the stacked washer and
dryer into place. Use felt pads or other sliding
device to assist moving and to protect flooring.
Dryer
Place
hands
here
Washer
Place
hands
here
15