Bostitch SMART POINT BTFP71917 Manual De Operación Y De Mantenimiento página 8

LOAdING THE BTFP71917
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE BTFP71917
1. Load nails through the slot in the rear of the magazine and past retaining clip.
2. Pull pusher back behind nail stick and release.
3. Ensure magazine pusher is behind the last nail stick.
TRIGGER LOCKOuT CONTROL
The trigger lockout control feature on BOSTITCH pneumatic tools provides a
trigger lock feature for added safety control. Push the lockout control button
in or out to activate or lock the tool trigger.
TRIP OPERATION MOdE
Always disconnect air supply before making adjustments as accidental actuation
may occur, possibly causing injury.
The BTFP71917 feature a selectable trigger system that allows the user to choose between the
following modes of operation:
1. Contact Trip Operation 2. Sequential Trip Operation
-8-
Trigger Lockout
Control Button