Tabla de contenido
Publicidad
PRoBLeM oR conceRn PossiBLe cause
Detergent is not dispensing The suction tube has been discon-
Detergent to Water ratio
Detergent - What to use
Circuit breaker trips or Fuse
blown in Fuse Box
GFCI Plug installation
GFCI Plug malfunction
Gun/Hose - Leaking water
Leaking Oil from Pump
Leaking water from bottom
of unit
8.0 tRouBLeshootinG
nected or clogged.
Circuit overload
Extension cord too long or wire
gauge too small
Nozzle partially blocked
Excessive pressure
A small amount of leakage is
normal
Machine Inlet connection is
defective
soLution
Make sure that the clear tube is properly con-
nected to the detergent nozzle. If it is not con-
nected then reconnect it.
Your Powerwasher draws detergent at a 10:1 ratio.
Most pressure washer detergents are generally
concentrated within that range so minimal
adjustment is required.
If you feel like you are using more detergent than
is required for the application you can dilute it with
regular tap water.
We recommend that you use a cleaner which is
specifically designed for power washers. There
are different kinds available depending on the
application. Check with your local Home Depot
store for the product which is best suited for your
needs.
never use Bleach, ammonia or hot
water in the unit.
Check that the circuit is rated at 15 amps or
greater. Make sure the unit is plugged into a
dedicated circuit.
Use proper extension cord as recommended in
owner's manual.
Clean Nozzle as instructed in section 6..
Clean Nozzle as instructed in section 6.
For GFCI reset procedures see owner's manual sec-
tion .. For instructions regarding the GFCI Plug in-
stallation or malfunction please email us directly at:
customerservice@huskypowerwasher.com
Gun/Hose will need to be replaced. Replacement parts
are not available for the Gun/Hose. Email us at:
customerservice@huskypowerwasher.com
for assistance or order online at:
www.huskypowerwasher.com.
If leakage occurs please contact us directly at
customerservice@huskypowerwasher.com
Check the Machine Inlet at the back of the unit
to ensure that water is not leaking from it. If the
connection is leaking it will have to be replaced.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
0
Publicidad
Tabla de contenido
