Remote Control; Basic Playback; Basic Operation - Nevir NVR-2313 DVD-X Manual De Instrucciones

Remote Control

POWER
0-9,10+NUMBER KEY
MUTE
N/P
SETUP
LEFT
MENU
DOWN
PLAY
STOP
REV
FWD
A-B
REPEAT
ZOOM
CLEAR
PBC
RESET
Please note in this Instruction book
represent the Navigation Arrows on the Remote Control.
When the batteries of the Remote control are exhausted, do NOT break open or
throw in a fire. Contact your local waste authority for disposal advice.
All manuals and user guides at all-guides.com
OPEN/CLOSE
SUBTITLE
ANGLE
LANGUAGE
PROGRAM
VIDEO
OSD
TIME
TITLE
UP
RIGHT
ENTER ENTER
RETURN
PAUSE
NEXT
PREV
SLOW
L/R
RANDOM
STEP
VOL-
VOL+
the arrows will be used to
8

Basic Operation

Introduction
1.POWER
2.STOP
3.PLAY/PAUSE
4.OPEN/CLOSE
1.Connect the Tv via the Scart lead to the DVD player
2.Turn on the Tv
3.Turn on the DVD player at the mains power switch
4.The red led will display that power is applied to the
DVD player
5.Either press the "Power" button on the player or
"Standby" on the R/C
6.This will enable the Tv to switch automatically to AV
and display the DVD "splash screen" on your Tv. If
your tv is of an older type that has not AV switching,
you must select AV manually on your Tv before
turning on the DVD player.
7.When the "Splash screen" is seen, press the Open/Close
button to open the DVD tray.
8.Place a DVD disc into the tray (label side up) and press
the Open/Close button again. (Do not push the DVD tray
to close) this may damage the mechanism.
9.The door will close and the DVD player will read the contents
of the disc and either start to play automatically or show a menu
of the discs contents.
10.To stop playing a disc, press "STOP" and remove the disc
as placing the disc.
11.When finished with the DVD Player, switch off using the Standby
button, the Tv will then revert to its normal operation.
12.If not using the DVD player again it is advisable, environmentally,
to switch the player off at the mains socket, rather than leaving in standby.

Basic Playback

4 3 2 1
9