Dolmar HT-CS 2 Manual De Instrucciones página 7

Storage
WARNING:
Follow the warnings and precautions in the
chapter "IMPORTANT SAFETY INSTRUCTIONS" and the
instruction manual of the power unit.
MAINTENANCE INTERVAL
-
Visually inspect for dam-
Whole unit
All fixing screws and nuts
Blades Inspect for damage, crack
Adjust the clearance
Supply grease
Gear case
Supply grease
Drive axle
Power unit
TROUBLE SHOOTING
State of abnormality
The motor does not start.
The motor stops soon after its start.
The maximum speed is limited.
The blades do not move.
Stop the motor immediately!
The blades do not move.
Stop the motor immediately!
The blades do not move.
Stop the motor immediately!
The unit vibrates abnormally.
Stop the motor immediately!
The blades do not stop.
Stop the motor immediately!
OPTIONAL ACCESSORIES
CAUTION:
These accessories or attachments are recom-
mended for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might present a
risk of injury to persons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding these accesso-
ries, ask your local Dolmar Service Center.
• Blade set
NOTE: Some items in the list may be included in the tool package
as standard accessories. They may differ from country to country.
Before operation
aged parts
Tighten
-
and dull edge
-
-
-
Probable cause (malfunction)
Refer to the instruction manual of the power unit.
Refer to the instruction manual of the power unit.
Refer to the instruction manual of the power unit.
Inappropriate angle of cutter unit.
A twig is caught by the blades.
The drive system does not work properly.
The drive system does not work properly.
The power unit does not work properly.
When storing the hedge trimmer attachment separated from the
power unit, put the cap onto the end of the shaft.
► Fig.10
Daily (10h)
-
-
-
-
-
Refer to the instruction manual of the power unit
Remedy
Refer to the instruction manual of the power unit.
Refer to the instruction manual of the power unit.
Refer to the instruction manual of the power unit.
Make sure the angle lock engages properly.
Remove the foreign matter.
Ask our authorized service center to inspect and repair it.
Ask our authorized service center to inspect and repair it.
Refer to the instruction manual of the power unit.
7 ENGLISH
25 h If required
- -
- -
- -
-
-
-