Powermate PRTT196E Manual Del Operador página 10

Assembly
(Continued)
• Save all instructions
ATTACH LOWER HANDLE
1. Loosen the lower handle bolts.
2. Align the lower handle holes to the middle height
adjustment holes in the transmission cover and install
the M10 x 25mm flange head bolts, lock washers and
nuts. Tighten all four bolts at this time.
ATTACH UPPER HANDLE
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the saddle bolts into the holes as shown and
securely with the handle knobs.
3. Tighten the handle knobs securely.
ATTACH FRONT HANDLE
1. Slide the front handle onto the outside of the base frame
and align the holes.
2. Install the four M8 x 25mm bolts, flat washers and locknuts
and tighten securely.
Questions? Call Toll Free at 1-800-737-2112
(See Figure 4)
(See Figure 5)
(See Figure 1)
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
Handle Knobs
Saddle Bolts
Copyright © 2012 MAT Engine Technologies, LLC
9
Height
Adjustment
Holes
Transmission Cover
Lower Holes
Figure 4
Handle Knobs
Saddle Bolts
Figure 5