Temperature Station; External Sensor - Auriol Z31743A Manual Del Usaurio

Mounting the temperature station and /
or the outdoor sensor on a wall:
Note: You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK OF
INJURY AND MATERIAL DAMAGE! Read
the operating and safety instructions for your drill
carefully.
that you do not hit electricity, gas or water lines
when you drill into the wall. If necessary, check
with a pipe and cable detector before drilling.

Temperature station

Mark the position of the hole (ø approx. 6 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
Hang the temperature station by placing the
hanger

External sensor

Mark the position of the hole (ø approx. 6 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
Hang the external sensor by placing the
hanger
84 GB/MT
DANGER TO LIFE! Take care
27
into the dowel.
26
on the screw.
23
32
into the dowel.
31
on the screw.
29
into the drilled hole.
into the drilled hole.