♦
Close the battery compartment i again .
The control LED r on the front of the
outdoor sensor lights up briefly .
Afterwards, the control LED r lights up
once every minute to signal that transmis-
sion is in progress .
Operating the temperature station
♦
Open the battery compartment q on
the rear of the appliance by removing the
battery compartment cover e .
♦
Insert two type AA batteries into the appli-
ance's battery compartment q as shown .
♦
Close the battery compartment q again .
Once the power supply has been established,
the display will light up and go through a brief
check of the display elements .
The temperature station will now attempt to
connect to the outdoor sensor . The reception
symbol
panel 4 .
NOTE
If no outdoor temperature is displayed within
around 3 minutes, the temperature station
will stop the reception search . The reception
symbol
the outdoor temperature panel 4 .
│
GB │ IE
■
42
flashes on the outdoor temperature
goes out and
is displayed on
AFT 77 A1