Braun Syncro System Smart Logic 7650 Manual Del Usuario página 11

Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely). Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles can
fall out.
For a thorough cleaning (weekly), remove the shaver
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation
time of the shaver, apply a drop of light machine oil onto
the shaver foil.
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
Syncro
and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
7000
(Shaver foil and cutter block: part no. 7000)
7000
Environmental notice
This product contains rechargeable batteries. In the
interest of protecting the environment, please do not
dispose of the product in the household waste at the
end of its useful life. Disposal can take place at a Braun
Service Centre or at appropriate collection points provided
in your country.
Subject to change without notice.
This product conforms to the European Directives
EMC 89/336/EEC and Low Voltage 73/23/EEC.
For electric specifications, see printing on the special
cord set.
11