Menu Setup - Abus HomeTec Pro CFT3000 Instrucciones De Montaje

remain, operation is not possible) or delete the user (user
is deleted entirely).
cancel confirm
f. MENU DRIVE
Door 1, Door 2, Door 3. Note: if you are using multiple drives on different doors,
select the required drive.
Overview Driving cycles: shows how many times the latch was pulled, unlocked
or locked. Lock: shows the lock position (locked or unlocked). The
number in the brackets shows the installed software version number.
Rename You can assign names when using multiple drives (e.g. front door,
garage etc.). Note: Name is freely selectable, scroll through alphabet
with . See:
Save the name with 3 seconds
Without code Lock without code. Note: If the menu option "lock without code" is
selected, you can lock the door simply by pressing
active. cancel
Automatic Automatic locking
Inactive, active.
If this function is enabled, you can set a time from - to,
in which the drive locks automatically. [hh:mm]
Note: In the set time it is regularly (approx. every 15 min.) queried whether
the drive is locked. This feature leads to higher energy consumption.
cancel confirm
Touch control Operating the drive keys
Active: all drive keys can be operated.
Operating keys: both arrow keys are deactivated on the drive
Inactive: all arrow keys are deactivated on the drive.
cancel confirm
Latch time time for which the latch is stopped when opening the door.
Can be selected with
cancel confirm
Latch power Medium, Low, High. (Recommendation: for optimal service life of
the drive and key, select the "Medium"/"Low" setting.)
cancel confirm
Signal Setting the acoustic in the drive
Latch: signal only sounds when pulling back the latch
Locked: signal only sounds when locked
Each end position: signal sounds when opened or locked
18
HomeTec_Pro_Tastatur_A6_160405_04.indd 18-19
5. INFO. Continue to next character with .
. Cancel with .
. Inactive,
confirm
0 - 9
from 1 to 20 seconds.
Inactive: no signal sounds for any position
Start of drive: signal sounds at the start of the opening or locking drive
cancel confirm
Reduced Locking is reduced to one-speed (e.g. one-speed even for two-speed
locking and opening of the door). We recommend permanent two-speed
locking.
Automatic, 1x closing.
cancel confirm
Drive power Setting the drive speed. (The "Automatic" setting should be
set permanently.)
Automatic, Maximum.
cancel confirm
g. MENU FACTORY RESET
Change with from NO to YES. 3 seconds
settings are deleted. cancel
h.MENU TIME ZONE
Time zone A, time zone B, ... time zone O (total of 15 time zones).
Open the programming of the 1st time zone with
You can assign these to different users under MENU e.
Scroll through the days with . sets the day as active (X) or inactive ( ).
Time from format [hh:mm], - , to
0 9
cancel confirm
i.MENU HISTORY
Shows the events of the drive, e.g. user 1 unlocked.
Note: the last event is shown, with one can switch to the event before the last event.
Maximum of 32 events are shown, whereby the latest overwrites the oldest. The entry
„admin" is logged in the event log for unlocking without a code or automatically locking.
cancel confirm
j. MENU SETUP
Greeting Note: Name is freely selectable, scroll through alphabet with
See: INFO. Continue to next character with
5.
name with 3 seconds
Signal Configuring the acoustic feedback
Display light time The display light time can be selected with
afterglow time.
cancel confirm
confirms. Factory reset is performed. All
. Set the different access times.
format [hh:mm], - .
0 9
.
. Save the
. Cancel with .
on, off, low.
from 2-10 seconds +
19
05.04.16 17:22