ASROCK ConRoe1333-eSATA2 Manual De Instrucciones página 20

FDD connector
(33-pin FLOPPY1)
(see p.2 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 16)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_BLUE (PORT0):
see p.2, No. 19)
(SATAII_BLACK (PORT1):
see p.2, No. 17)
(SATAII_RED (PORT2):
see p.2, No. 21)
(SATAII_ORANGE (PORT3):
see p.2, No. 15)
SATAII_RED (PORT2) and SATAII_ORANGE (PORT3) connectors can be
used for internal storage devices or be connected to eSATAII_BOTTOM
and eSATAII_TOP connectors with corresponding color to support eSATAII
devices. Please read "eSATAII Interface Introduction" on page 26 for
details about eSATAII and eSATAII installation procedures.
eSATA II Connectors
(eSATAII_TOP: see p.2, No. 37)
(eSATAII_BOTTOM: see p.2, No. 36)
Serial ATA (SATA)
Data Cable
(Optional)
2 0 2 0 2 0
2 0 2 0
ASRock ConRoe1333-eSATA2 Motherboard
80-conductor ATA 66/100 cable
These four Serial ATA II
(SATAII) connectors support
SATAII_ORANGE (PORT3)
SATA data cables for internal
storage devices. The current
SATAII_RED (PORT2)
SATA II interface allows up to
3.0 Gb/s data transfer rate.
SATAII_BLACK (PORT1)
SATAII_BLUE (PORT0)
These two eSATA II
connectors support SATA
data cables for external
SATAII function. The current
eSATA II interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
You can also use the SATA data
cable to connect SATAII connec-
tors and eSATAII connectors
with corresponding color.
the red-striped side to Pin1
connect the black end
to the IDE devices