Black+Decker GST26 Manual De Instrucciones página 26

26 • ENGLISH
Problem
Engine cranks - starts
hard/doesn't start
Engine runs, but dies
or does not accelerate
properly
Engine does not crank
TROUBLESHOOTING
Check
Fuel at carburetor No fuel at carburetor
No fuel at cylinder
Fuel at cylinder
Muffler wet with fuel
Spark at end of plug
No spark
wire
Spark at plug No spark
Air filter Air filter dirty
Fuel filter Fuel filter dirty
Spark plug Plug dirty/worn
Carburetor Improper adjustment
Cooling system dirty/
Cooling system
plugged
N/A N/A
Status
• Fuel dtrainer clogged
• Fuel line clogged
• Carburetor
Carburetor
Fuel mixture too rich
• Stop switch off
• Electrical problem
• Interlock switch
• Spark gap icorrect
• Covered with carbon
• Fouled with fuel
• Plug defective
Normal wear
Contaminants/residues
in fuel
Normal wear
Vibration
Extended operationin
dirty/dusty locations
Internal engine problem
Cause
• Clean or replace
• Clean or replace
• See your
BLACK+DECKER
Service Center
See your
BLACK+DECKER
Service Center
• Open choke
• Clean/Replace air filter
• Adjust carburetor
• See your
BLACK+DECKER
Service Center
• Turn switch to ON
• See your
BLACK+DECKER
Service Center
• Adjust to 0.65mm (.026")
• Clean or replace
• Clean or replace
• Replace plug
Clean or replace
Replace
Clean and adjust or replace
Adjust
Clean
See your
BLACK+DECKER
Service Center
Remedy
(I)