Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
INSTALLATION
Attachment
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the mounting brackets of the device, there are the holes for the installation.
Step 2: Hold the mounting brackets with the device onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the mounting brackets in the desired position and tighten them.
Adjust the desired inclination-angle via the mounting brackets and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Attention: After mounting the luminaries in the desired location, be sure to tighten the screw on the
underside of the mounting brackets with an imbus key. This prevents a possible slipping of the device.
DMX-512 connection / connection between fixtures
The wires must not come into contact with each other, otherwise
Permanent installation is recommended!
DANGER TO LIFE!
the fixtures will not work at all, or will not work properly.
15/35
00042630.DOC, Version 1.0
Publicidad
Tabla de contenido
