Bosch Professional GWS 1000 Manual Original página 26

OBJ_BUCH-310-002.book Page 27 Monday, October 27, 2008 2:16 PM
The protection guard 11 may be turned only
upon actuation of the release lever 1! Oth-
erwise the power tool may not continue to
be used under any circumstances and must
be taken to an after-sales service agent.
Note: The encoding keys on the protection
guard 11 ensure that only a protection guard
that fits the machine type can be mounted.
Protection Guard for Cutting
For cutting metal, always work with the pro-
tection guard for cutting 12.
For cutting stone, always work with the cut-
ting guide with dust extraction protection
guard 19.
The protection guard for cutting 12 is mounted
in the same manner as the protection guard for
grinding 11.
Extraction Hood for Sanding
The extraction hood 6 can be used for low-dust
sanding of paint, varnish and plastics in con-
junction with the carbide grinding head 8 or the
rubber sanding plate 15 with a sanding sheet
16. The extraction hood 6 is not suitable for
working metals.
A suitable Bosch vacuum cleaner can be con-
nected to the extraction hood 6.
The extraction hood 6 is mounted in the same
manner as the protection guard 11. The brush
collar is exchangeable.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 4.
Screw the auxiliary handle 4 on the right or left
of the machine head depending on the working
method.
Hand Guard
For operations with the rubber sanding
plate 15 or with the cup brush/wheel
brush/flap disc, always mount the hand
guard 14.
The hand guard 14 is fastened with the auxiliary
handle 4.
Bosch Power Tools
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Clean the grinder spindle 5 and all parts to be
mounted.
For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock
button 2.
Actuate the spindle lock button only when
the grinder spindle is at a standstill. Other-
wise, the machine may become damaged.
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding
tools. The mounting hole diameter must fit the
mounting flange without play. Do not use reduc-
ers or adapters.
When using diamond cutting discs, pay atten-
tion that the direction-of-rotation arrow on the
diamond cutting disc and the direction of rota-
tion of the machine (see direction-of-rotation ar-
row on the machine head) agree.
See graphics page for the mounting sequence.
To fasten the grinding/cutting disc, screw on
the clamping nut 9 and tighten with the two-pin
spanner; see Section "Quick-clamping Nut ".
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn free-
ly. Make sure that the grinding tool does
not graze against the protection guard or
other parts.
An O-ring (plastic part) is in-
serted in the mounting flange 7
around the centring collar. If
the O-ring is missing or is
damaged, it must in all cases
be replaced (article number
1 600 210 039) before the
mounting flange 7 is mounted.
1 609 929 K94 | (27.10.08)
English | 27