Tabla De Contenido; Models Available - GE Advantium ZSC1001 Manual Del Usuario

BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
-
Save these instructions
for local inspector's use.
IMPORTANT -
Observe all governing codes
and ordinances.
Note to Installer -
•
instructions with the Consumer.
Note to Consumer
•
with your Owner's Manual for future reference.
Skill Level
Installation of this appliance
• -
requires basic mechanical and electrical skills.
Completion Time
•
• Proper installation is the responsibility
of the installer. Product failure due to improper
installation is not covered under the warranty.
See Owner's Manual for warranty information.
NOTE: This oven is only approved to be installed
under the specific models as labeled on this unit.
IMPORTANT -
Use this oven only for its
intended purpose. Never use the oven for
warming or heating a room. Prolonged use
of the oven without proper ventilation can be
hazardous.
CAUTION
For personal safety, remove
house fuse or oven circuit
breaker before beginning installation to avoid
severe or fatal shock injury.
CAUTION
For personal safety, the
mounting surface must
be capable of supporting the cabinet load, in
addition to the added weight of the oven and
drawer, plus additional oven loads.
CAUTION If installing the Advantium
120V Oven below 36 ,
you must use the plastic bottom trim due to
burn risk to children. The plastic trim acts as
insulation and will help prevent burns to children
from hot surfaces.
If installing the Advantium
CAUTION
120V Oven below 36 , do not
remove the plastic door trim due to burn risk
to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.
Safety Information
Be sure to leave these
- Keep these instructions
-
1 Hour.
CONTENTS
Design Information
Models Available ............................................... 2
Product Dimensions and Clearances ................ 3
Tools Required .................................................. 3
Parts Supplied ................................................... 3
Installation Preparation
Electrical Requirements .................................... 4
Preparing the Opening (Standard) .................5-6
Remove Packaging (Standard) ......................... 6
Preparing the Opening (Flush Mount) ............7-8
Remove Packaging (Flush Mount) .................... 8
Installation Instructions
Step 1, Slide the Oven into the Cutout ............. 9
Step 2, Install Bottom Trim ................................ 9
Step 3, Install Side Trim .................................... 9
Step 4, Install Mounting Screws ........................ 9
Step 5, Finalize Installation ............................... 9

MODELS AVAILABLE

Monogram Models:
ZSC1001 SS-Stainless Steel
2