Before Using For The First Time; Boiling Water; Cleaning And Maintenance - Bosch TWK3A Serie Instrucciones De Uso

6
Before using
for the first time
● Remove any stickers or film.
● Unroll the right amount of cable from the
cable tidy 6 and plug it in.
● Fill the kettle 1 with water. Bring the
water to a boil and discard it. Repeat the
procedure. This will make sure that the
kettle is clean for normal use.
● When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Boiling water
● Remove the lid 2 and fill the kettle 1 with
fresh water through the opening or spout.
● Read the quantity on the water level
indicator. Do not fill with less than
0.25 litres or more than 1,7 litres of water!
● Put on the lid 2 at the
to to lock it in place.
● Press down the O / I ON/OFF switch 3;
the switch lights up. The water is heated.
● The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off at
any time by pulling up the O / I ON/OFF
switch 3.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
Robert Bosch Hausgeräte GmbH
mark and twist
N.B.: Only operate the kettle with the lid 2
closed and the limescale filter 4 inserted,
otherwise the kettle will not switch off.
For physical reasons, the base 5 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.
Cleaning and
maintenance
¡
Risk of electric shock!
Never immerse the device in water or place
it in the dishwasher!
Do not steam-clean the appliance.
● Before cleaning, unplug the appliance
from the power outlet.
● Clean the outside of the kettle 1 and base
5 with a damp cloth. Do not use strong or
abrasive cleaning agents.
● Remove the limescale filter 4, soak it in a
little vinegar, then rinse clean with clear
water.
● Rinse the kettle 1 and the limescale filter
4 with clear water.
en de