Tabla de contenido
Publicidad
Maintenance
Mantenimiento
Entretien
1
2
Maintenance
Timeout Feature:
Water will stop flowing 4 minutes after the faucet
is last touched.
If faucet exhibits very low flow:
A. Remove and clean Aerator (1) with supplied
wrench (2).
B. SHUT OFF WATER SUPPLIES. Replace valve
cartridge (5). When reinstalling parts, make sure
bonnet nut (6) is tightened securely with
a wrench.*
If faucet leaks from under handle:
Remove handle and unthread trim sleeve (7).
Using a wrench, ensure bonnet nut (6) is tight.
If leak persists–SHUT OFF WATER SUPPLIES.
Replace valve cartridge (5). When reinstalling
parts, make sure bonnet nut (6) is tightened
securely with a wrench.*
If faucet leaks from spout outlet–SHUT OFF
WATER SUPPLIES. Replace valve cartridge (5).
When reinstalling parts, make sure bonnet nut (6)
is tightened securely with a wrench.*
* WARNING: Failure to securely tighten bonnet
nut with a wrench could result in water
damage.
Note: A small amount of water may run out the
spout or drip for a very short period after the faucet
is shut off. This is a natural occurrence caused by
the long flexible hose.
Note: Do not attempt to disassemble cartridge (5).
There are no repairable parts inside.
8
If touch function stops working after service to
faucet or connections:
Reset system by removing batteries for 30 seconds
then reinstalling.
LED Guide
If LED (8) is:
Solid Blue - Solenoid valve is open, water
temperature is less than 80
Solid Magenta - Solenoid valve is open, water
temperature is between 80
(43
Solid Red - Solenoid valve is open, water
temperature is greater than 110
3 red flashes before solenoid opens or closes -
replace batteries.
Note: If low battery indication is on after
installing fresh batteries, please check that
batteries are loaded in the proper direction in
the battery box.
38
1/8"
°
C).
Cleaning and Care
Care should be given to the cleaning of this
product. Although its finish is extremely durable, it
can be damaged by harsh abrasives or polish. To
clean, simply wipe gently with a damp cloth and
blot dry with a soft towel. Glass cleaner can be
used on SS (Stainless) finish to remove fingerprints
and maintain color match. You can avoid turning the
faucet on and off by closing the handle.
7
6
5
°
°
).
F (27
C
°
°
°
C) and 110
F (27
F
°
°
F (43
C).
Publicidad
Tabla de contenido
