Transfer Of Data To A Pc; Deleting Data; Communication; Ir/Rs232-Protocol - HUBER INSTRUMENTE HM35 Manual De Instrucciones

Notes
1) „Over" (data type DISCRETE) for invalid pressure value
2) For the Data Type key, refer to the table on Page 52.
3) User-interval period will, for example, be displayed as follows, "user 01:15:00"
3.6.2

Transfer of data to a PC

(with HM35 Communication Software)
Install the IR (IrDA) -adapter according the instructions of the manufacturer.
1.
Install the HM35 Communication Software.
2.
Start the HM35 Communication Software.
3.
Place the instrument max. 20 cm from the IR (IrDA)-Adapter and switch it on.
4.
Ensure a line-of sight connection between instrument and IR-adapter!
If there is no communication with the instrument for more than 2 minutes, the IR
interface of the instrument turns off automatically! By restarting the instrument the
IR interface is reactivated.
3.6.3

Deleting data

In the Menu, select the Data Logging → Clear Memory function.
1.
Press the Clear key.
2.
3.7

Communication

3.7.1

IR/RS232-Protocol

COM-Port Settings
Baudrate 9600
Data bits 8
Parity no
Protocol no
Stop bit 1
Communication Protocol
Coding
The characters are transfered as ASCII-Code.
44