7�6 Registering A New Drink Container; 7�7 Switching Off The Drink Manager; Cleaning And Maintenance; Important - Beurer DM 20 Instrucciones De Uso

7.6 Registering a new drink container
1� Press the ON/OFF/cup button� The LED display starts to flash white�
2� Place the new drink container (e�g� glass, cup or beaker) in the centre of the drink manager surface� Make
sure that the drink container is completely full�
3� Once the new drink container has been registered successfully, the white LED display goes out and an
acoustic signal sounds� If you now drink from the new drink container and then place it back on the surface
of the device, the drink manager automatically detects the volume that has been drunk�
7.7 Switching off the drink manager
To switch off the drink manager, press and hold the ON/OFF/cup button for 3 seconds� An acoustic signal con-
firms that the drink manager has switched off�

8. Cleaning and maintenance

If dirty, clean the surface of the device with a damp cloth� You may also apply a small quantity of detergent if
required�

IMPORTANT

• Never use harsh solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher�

9. What if there are problems?

Problem
The device will not switch on�
The recorded data is not trans-
ferred to the smartphone�
Solution
The batteries are empty� Replace the batteries�
1� Completely close the app (including in the background)�
2� Switch Bluetooth on the smartphone off and on again�
®
3� Switch smartphone off and on again�
4� Remove the batteries from the drink manager for a short period and
reinsert them�
5� See FAQs at www�beurer�com
22