Coleman 9930 Serie Instrucciones De Uso página 5

WARNING
This product is fueled by propane
gas. Propane gas is invisible,
odorless, and flammable. An odorant
is normally added to help detect
leaks and can be described as a
"rotten egg" smell. The odorant can
fade over time so leaking gas is not
always detectable by smell alone.
Only cylinders marked "propane"
must be used.
Use only propane gas set up for
vapor withdrawal.
Propane gas should be stored
or used in compliance with local
ordinances and codes or with ANSI/
NFPA 58. Turn off propane and
disconnect cylinder when not in use.
Cylinders must be stored out of
reach of children.
CALIFORNIA PROPOSITION 65:
WARNING: This fuel, and by products
of combustion of this fuel, contain
chemicals known to the state of
California to cause cancer, birth defects,
or other reproductive harm.
WARNING
BURN HAZARD
Never leave grill unattended when
hot or in use.
Keep out of reach of children.
CAUTION
SERVICE SAFETY
Keep all connections and fittings
clean. Inspect propane cylinder and
grill propane connections for damage
before attaching.
During set up, check all connections
and fittings for leaks using soapy
water. Never use a flame. Bubbles
indicate a leak. Check that the
connection is not cross-threaded
and that it is tight. Perform another
leak check. If there is still a leak,
remove the cylinder and contact
Coleman for service or repairs.
Use as a cooking appliance only.
Never alter in any way or use with
any device or part not expressly
approved by Coleman.
Clean grill frequently to avoid
grease accumulation and possible
grease fires.
Technical
Characteristics
Input: 10,000 BTU/h
Category: Pressure regulated propane
Fuel: 16.4 oz. disposable propane
cylinders
Regulator: 9930
To Set Up
CONSUMER NOTICE: These assembly
instructions are designed for more than
one grill model. Some features and
components shown may not be included
with your grill.
■ Remove components from carton.
(Fig. 1)
Table Top Grill
Grill Grate
Regulator Assembly
Drip Tray
Lid Handle Assembly
Igniter Assembly
■ Assemble handle to lid. Place the
handle in proper location. Install the
screw and a washer through the inside
of the lid and the handle insulator.
Tighten the screws with a phillips
screwdriver. (Fig. 2)
NOTE: Take care to not over-tighten
the screws. The screwdriver is
included with the grill.
English - 5
Fig. 1
Fig. 2