Panadero ANDES Instrucciones De Utilización Y De Mantenimiento página 6

- The glass, brass pieces and stove in general may reach very high temperatures. Do not
expose yourself to risks of burns. When handling metal pieces, use the glove provided
with the stove.
- Keep children away from the stove.
- If you have trouble lighting the stove (due to cold weather, etc.) it can be lit with folded
or scrunched up paper which is easier to light.
- In case of the stove becoming too hot, close the air draughts to reduce the intensity of
the fire.
- In case of malfunction, contact us the manufacturers.
- For optimum performance, on ignition open only the primary air and once the fire
gets going (1 or 2 minutes) close off most of the primary air leaving only a very small
opening to allow for slow combustion.
-
When you place the logs in the oven's firewood rack, ensure they are not in
contact with the top
MAINTENANCE
- It is advisable to clean the glass door panel periodically to avoid blackening by soot
deposits. Professional cleaning products are available for this. Never use water. Never
clean the stove while it is in use.
- It is also important to clean the smoke outlet tubing periodically and check there are
no blockages before relighting fuel after a long period of non-use. At the start of each
season a professional should carry out a revision of the installation.
- In the event of a fire in the smoke outlet, close all air draughts if possible and contact
the authorities immediately.
- Any replacement part which you may need must be recommended by us.
- The fiberglass cord used for the j o ints may degrade over time. If this happens, you will
have to replace it with a new fiberglass tape.
GUARANTEE
This is a high quality stove, manufactured with great care. Even so, if any defect is found
please first contact your distributor. If they are unable to solve the problem they will contact
us and send us the stove if necessary. Our company will replace any faulty parts free of
charge up to five years from the date of purchase. We will not charge for repair work,
however any transport costs must be paid by the client.
If any deformation occurs inside the combustion chamber, this is due to overheating of the
device and therefore NOT covered by the warranty.
Since this apparatus has been tested by a homologated laboratory the following parts are
NOT covered by warranty:
-Glass
-Internal grate
-Vermiculite
-Door handle, air-inlet knobs, etc.
In the interior of the packaging, you will find a quality control slip. We request that you
send this to your distributor in case of any claim.
6