Controlling The Temperature - essentiel b ECHS 2001VH Instrucciones De Uso

Medium intensity: the appliance runs on medium power
and the
intensity bar is half lit. The selected temperature is shown
on screen.
Ventilation: the appliance does not heat and ventilates
ambient air. The
are displayed on screen.
Eco: the appliance automatically adjusts the heating power
to keep the temperature in the room constant. The
symbol, the selected temperature and the word "eco" are
displayed on screen.
The power consumption depends on the selected heat position. For
improved energy efficiency, select a high heating power first (2000 W), then
switch to low power (1200 W) once the desired heat has been reached.

Controlling the temperature

Having selected the "High intensity" or "Medium intensity" or "Eco" mode, press the
and buttons on the control panel or remote control repeatedly until you reach the desired
temperature (between 5 and 35°C). The selected temperature is displayed and the screen
flashes for 10 seconds once it has been reached.
The heating function turns on and off automatically to keep the room at the temperature you
have selected.
The temperature control does not work in "Ventilation" mode.
18
V.2.0
use
and symbols are displayed on screen. The
symbol and the selected temperature
Oscillation function
1. When the appliance is switched on, press the
control to activate the oscillation. The flaps inside the appliance oscillate at a 90° angle and
the oscillation symbol appears on screen.
2. Press this button again to deactivate the oscillation. The oscillation symbol goes out. The
appliance remains in the position it was in at the time of deactivation.
Programming the timer
The timer allows you to program both an appliance auto-off (e.g. for the appliance to stop
automatically at a certain time) or a delayed start (e.g. for the appliance to heat the room
before you enter).
PROGRAMMING AN AUTO-OFF
1. When the appliance is switched on, press the
control.
2. Press the and buttons on the control panel or remote control repeatedly to set the
desired operating time (1 to 24 hours). The
on screen during setting.
When setting is complete, the hour countdown begins and the screen shows the
temperature again.
3. When the time has elapsed, the appliance automatically stops operating and goes into
standby mode.
Note: the timer is deactivated if the appliance is switched off using the
countdown.
PROGRAMMING A DELAYED START
1. Switch on the appliance, select a heating mode, temperature and oscillation if desired by
referring to the previous sections.
2. Switch off the appliance by pressing the
3. Press the button on the control panel or remote control.
4. Press the and buttons on the control panel or remote control repeatedly to set the
time after which the appliance will start operating (1 to 24 hours). The
selected time are displayed on screen during setting.
When setting is complete, the hour countdown begins.
5. When the time has elapsed, the appliance starts automatically.
MODIFYING OR CANCELLING AN AUTO-OFF AND A DELAYED START
1. To change a timer which has already been programmed, press the
the and buttons repeatedly until you reach the desired time.
2. To cancel the current timer, press the
until the display shows "0". The screen switches off completely.
button on the control panel or remote
button on the control panel or remote
symbol and the selected time are displayed
button during the
button.
symbol and the
button, then press
button, then press the and buttons repeatedly
V.2.0
19
use