Programming Mode - Test Mode - LG GCWP1069CS1 El Manual Del Propietario

PROGRAMMING MODE -
Diagnostic tests:
This program has been added for testing the washer and detecting errors.
Entering the test mode
Data Name
1. Entering
Entering
programming mode
the test mode
2. Hot
3. Start
1.
According to pressing Start button, test move to the next step.
Number of times the
START button is pressed
None
Turns on all lamps and locks the
1 time
door
2 times Tumble Clockwise.
3 times Low Speed Spin
4 times High Speed Spin
5 times Inlet valve for main water turns on.
6 times Inlet valve for hot wash turns on.
7 times Inlet valve for bleach turns on.
8 times Inlet valve for atomizing turns on.
9 times Tumble counter clockwise.
10 times Turn on Circulation Pump.
11 times Drain Pump turns on.
12 times Turns on all lamps.
13 times Button Checks.
14 times High Speed Spin
15 times
16 times
NOTE
• Make sure the drum is empty when a diagnostic test is performed. Do not use
(display)
Button Display
Check Point
PDA Signal Check

PROGRAMMING MODE - TEST MODE

TEST MODE
Description
Insert service card (card type), turn on/off
toggle switch (card type).
Press the Hot button. Then
in the display.
Enter the diagnostic test mode.
Display
Displays 1U:XX, 1g:XX and 12:XX
alternately (Version)
rpm (40~50)
rpm (600)
rpm (1150)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
rpm (40~50)
Water level frequency (255~)
Water level frequency (255~)
Displays 1U:XX, 1g:XX and 12:XX
alternately (Version)
rpm (1150)
this function is not applied in this
machine
61
appears
.