Programming Mode - Test Mode - LG FH069FDF Manual De Usuario

PROGRAMMING MODE -
Diagnostic tests:
This program has been added for testing the washer and detecting errors.
Entering the test mode
Data Name
1. Entering
Entering
programming mode
the test mode
2. Hot
3. Start
1.
According to pressing Start button, test move to the next step.
Number of times the
START button is pressed
None
1 time Turns on all lamps and locks the door
2 times Tumble Clockwise.
3 times Low Speed Spin
4 times High Speed Spin
5 times Inlet valve for main water turns on.
6 times Inlet valve for hot wash turns on.
Inlet valve for atomizing turns on (single model).
7 times
Inlet valve for softener turns on (stack model).
Inlet valve for bleach turns on (single model).
8 times
Inlet valve for atomizing/bleach turns on (stack model).
9 times Tumble counter clockwise.
10 times Heater turns on.
11 times Turn on Circulation Pump.
12 times Drain Pump turns on.
13 times Turns on all lamps.
14 times Button Checks.
15 times High Speed Spin
16 times
17 times
NOTE
• Make sure the drum is empty when a diagnostic test is performed. Do not use
(display)
Button Display
Check Point
PDA Signal Check

PROGRAMMING MODE - TEST MODE

TEST MODE
Description
Insert service card (card type)
Turn on/off toggle switch (coin type)
Press the Hot button. Then
in the display.
Enter the diagnostic test mode.
Displays
14:XX alternately (Version)
rpm (40~50)
rpm (600)
rpm (1150)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
rpm (40~50)
Displays water temperature
Water level frequency (255~)
Water level frequency (255~)
Displays
14:XX alternately (Version)"
rpm (1150)
this function is not applied in
this machine
67
appears
Display
, 1U:XX, 1g:XX and
, 1U:XX, 1g:XX and
.