CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward
to arrange them as they were before you removed the door. Wires that are not
connected or arranged correctly can be caught in the door or damaged by heat.
NV51K7770S_AA_DG68-00857A-03_EN+MES+CFR.indb 55
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in
the corners of the oven door, and
rotate the hinge locks toward the oven
cavity to the locked position. See Step
3 (illustration A) in the "Removing the
oven doors" section for the proper
locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8.
Reconnect the LED light's Wire Harness.
Changing the oven light
The oven light is a standard 40-watt appliance halogen bulb. It comes on when the
oven door is open. When the oven door is closed, touch Lamp
on or off. It will not work during a self-cleaning or Hybrid cleaning cycle.
1.
Important: The broil heater is not a
removable part. Do not force the broil
heater down. Do not let it drop down.
01
2.
3.
4.
5.
Before changing your oven light, disconnect
the electrical power to the oven at the main
fuse or circuit breaker panel. Make sure the
oven and the halogen bulb are cool.
to turn the light
To change the halogen bulb, you must
tilt the broil heater down. To do this,
turn the circular nut on the support
counterclockwise while holding the
broil heater. The broil heater should
loosen and tilt down.
Remove the glass cover.
Remove the halogen bulb cover.
Replace the halogen bulb.
When done, replace the glass cover, and
then follow Step 1 above in the reverse
order to return the broiler to its correct
position.
CAUTION
English 55
2018-08-29
2:18:39