Specifications - Dimplex Revillusion 30" Firebox Manual Del Usuario

Specifications

The Revillusion™ Built-in Electric Firebox offers an alternative to a wood or gas
fireplace. It can give your existing fireplace new life or transform a cabinet or media
center of your own into a stunning focal point.
Dimensions
RBF30 RBF36
Width 31 1/8" 37 1/8"
792 mm 944 mm
Height 26 5/8" 26 5/8"
676 mm 676 mm
Depth 12 1/8" 12 1/8"
307 mm 307 mm
Weight
RBF30 RBF36
50 lbs 60 lbs
22.7 kg 27.2 kg
Operation Temperature
-4 to 104 F (-20
o o
WARNING: Electrical outlet wiring must
comply with local building codes and other
applicable regulations to reduce the risk of
fire, electric shock, or injury to persons.
!
NOTE: A 13Amp (EU) or 10 Amp(AU/
NZ) circuit is required. A dedicated circuit
is preferred, but not essential in all cases.
A dedicated circuit will be required if, after
installation, the circuit breaker trips or the
fuse blows on a regular basis when the
heater is operating. Additional appliances
on the same circuit may exceed the current
rating of the circuit breaker.
6
RBF36P RBF42
37 1/8" 43 1/4"
944 mm 1098 mm
31" 31"
788 mm 788 mm
12 1/8" 12 1/8"
307 mm 307 mm
RBF36P RBF42
65 lbs 70 lbs
29.5 kg 31.8 kg
to 40 C)
o o
Unpacking the Unit
The unit comes packed with a protective
sheet covering the front of the unit. This
sheet is intended to prevent dust and
debris from entering during construction.
This sheet is designed so that it can be
partially removed to complete the wiring
and unpacking and can be reinstalled
until the final installation is complete.
The log set was installed on the grate
and the grate permanently fixed to the
firebox at the factory.
Carefully remove the packaging from
around the log set. Make sure the wires
from the log set are connected securely
to the grate box.
CAUTION:
LEDs to create a unique pulse and glow
effect. Handle the log set carefully. They are
fragile and can crack or break if dropped.
Technical Information
Model No: RBF30-EU, RBF36-EU, RBF36P-EU, RBF42-EU
Heat Output
Nominal Heat Output
Minimum Heat Output
Maximum Continous Heat Output P
Auxiliary Electricity Consumption
In Standby mode
with electronic room temperature control
The Realogs™ contain
230V
P 1.8 - 2.0 kW
Nom
P - -
min
1.8 - 2.0 kW
max,c
el 0.47 - 0.49 W
SB
240V
- kW