Dimplex Revillusion 30" Firebox Manual Del Usuario página 8

Installation
Placement
This firebox is a zero clearance design,
with the exception of the top of the unit,
where any insulation and vapor barrier
should be placed a minimum of 2"
(5.1 cm) from the firebox.
DANGER!:
be generated under certain abnormal
conditions. Do not partially or fully cover or
obstruct the front of the firebox.
WARNING: All electrical heaters have
hot and arcing or sparking parts inside. Do
not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
WARNING: The built-in electric firebox
must NOT be in direct contact with any
building vapor barrier or insulation.
1.
Place the firebox into the framed
opening. Level
necessary.
2.
From the inside of the unit, gently
remove the interior brick panels
(attached magnetically) and bent
out, up to 90°, to be flush with the
surrounding studs.
3.
Attach the firebox to frame using four
mounting flanges on the sides of
firebox and suitable hardware.
8
High temperatures may
with shims
Fixed Wiring
In some jurisdictions this appliance
is supplied without a plug this is to
comply with the local regulations. In
such instances this appliance must be
installed by a suitabily quailified installer
and the means for disconnection must
be incorporated in the fixed wiring in
accordance with the local wiring rules.
if