The washing
machine does not
drain or spin.
Does the selected program
incorporate water drai-
ning? Some programs stop
at the end of the wash cycle
and draining will have to be
selected manually.
Is the "Easy iron" function
-where provided - enabled?
This
function
requires
manual
selection
draining.
Is the drain pump clogged?
To check it, turn off the water
supply, unplug the washer-
dryer
and
follow
instructions on page 18, or
call technical support.
Always get
assistance from
authorized service
agent and always
insist on original
spare parts.
Cleaning Filters
Drain: to avoid flooding
be careful to the adjust the drain
hose to at least
25" above the base
of the appliance.
Fasten the hoses securely.
www.aristonappliances.us
Is the drain hose kinked?
The drain hose must be as
straight as possible. Make
sure the drain hose is not
crimped or kinked.
Is the washing machine's
drain hose clogged? Is
there an extension of the
drain hose? If so, is it
positioned
incorrectly,
blocking the water flow?
for
Excessive vibration
during the spin cycle.
the
Have all shipping bolts
been removed during
installation?
following
page
installation procedures.
Has the washing machine
been levelled correctly?
The
levelling
appliance
should
checked periodically. Adjust
the feet and check them with
a level.
Remove filters
using tweezers,
clean and replace
Is there space between the
machine and adjacent
units? If it is not a built-in
model, the washing machine
will oscillate a bit during the
spin cycle. An inch or two of
space should therefore be
left around it.
The washing
machine leaks.
Is the metal ring of the inlet
hose properly attached?
Turn off the water supply,
unplug the appliance and try
tightening its attachment
without forcing it.
See
the
Is the detergent dispenser
on
obstructed? Remove and
wash it under tap water.
Is the drain hose well
attached? Turn off the water
of
the
supply,
be
appliance and try tightening
its attachment.
Remove
filters, clean
and replace
Tape
Too much foam.
Is the detergent appropriate
for washing machine?
Check whether the definition
on its label reads "for machine
wash" or "hand and machine
wash", or any other similar
wording.
Is the correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.
.If, despite all checks, the
washer-dryer fails to function
and the problem persists, call
your nearest authorized
Customer Service Centre,
1-888-426-0825 providing
the following information:
- the nature of malfunction
- the model type no. (Mod. ....)
unplug
the
- the serial number (S/N ....)
This information can be found
on the data plate situated at the
back of the washer-dryer.
Tape
Instructions for installation and use
Tape
17