Hergom E-30 Serie Instrucciones Para Instalación, Uso Y Mantenimiento página 18

HANDLE
4 - LIGHTING UP AND USE
Important at first start: may come off a few drops
of condensed water from the stove, produced by
the humidity of the environment where the stove
was stored.
It is very important that the first time the heater is
lit, it is done so slowly.
This is for the following reasons:
• Stabilise cast iron parts.
• Harden the joint sealant putty. Advise:
• We recommend that the first loads of fuel be
small.
• To generate draw, heat the chimney by
introducing some burning paper in the gap
between the front and the deflector, directing
it toward the chimney.
• While lighting for the first time, ensure the
room where the heater is located is well
ventilated as the paint work may let off some
fumes.
• Keep the stove on for a few hours at this
intensity.
• IMPORTANT! The total height of the fire load
should not exceed 50% of the height of the
combustion chamber.
• The heater must be closed at all times during
combustion to prevent smoke from leaking
out. Only open to add fuel.
Daily use
After lighting up for the first time, your heater will
be ready for daily use.
Your heat requirements will be obtained based on
the frequency and the amount of firewood you
load.
When your heater is cold, we recommend lighting
it up slowly.
Overheating.
Overheating means that you have operated your
heater at a excessively high temperatures for a
long period of time. This can damage your
appliance and, therefore, it is a situation that
FIG. 5
must be avoided.
Overheating is the result of excessive draw, due to
any of the following reasons:
• The Primary Air Valve is excessively open for
the type of wood being used.
• The chimney is too big.
• Improper maintenance of the stove, which
may result in air infiltration.
• Inappropriate
• Door not closed correctly. ATTENTION!
During the operation of the stove, the ash pan
cover must be perfectly positioned to seal the fire
box.
Any uncontrolled
overheating that can damage the stove.
HEATERS WITH ENAMEL IN MAJOLICA
VERY IMPORTANT!
In the case of stoves enamelled in Majolica, it is
normal for slight fissures to appear in the glazing,
providing the product with its characteristic
appearance, once the heater is lit.
However,
overheating, these fissures caused by the
different expansion levels of the cast iron and the
Majolica enamel with vitreous components, can
cause the enamel to chip.
To avoid this inconvenience, control combustion
and never overheat the heater.
INDUSTRIAS HERGÓM S.A. may not be held
liable for the deterioration of the stove's enamel if
these instructions are not followed.
fuel
high temperatures.
intake
in the event
that produces
of air produces
of uncontrolled