Sony SRS-X99 Manual De Instrucciones página 3

Ocultar thumbs Ver también para SRS-X99:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Declaration of Conformity
Trade Name:
Model No.:
Responsible Party:
Address:
Telephone No.:
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software,
which is the passed down through the MAC,
through the digital and analog baseband, and
finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the
digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of
the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is
being transmitted. In other words, this device
automatically discontinues transmission in case of
either absence of information to transmit or
operational failure.
Frequency Tolerance: ±20ppm
5.15-5.25 GHz band is restricted to indoor
operations only.
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer's
instructions.
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than the
other. A grounding type plug has two blades
and a third grounding prong. The wide blade or
the third prong are provided for your safety. If
the provided plug does not fit into your outlet,
consult an electrician for replacement of the
obsolete outlet.
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11) Only use attachments/accessories specified by
the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
SONY
SRS-X99
Sony Electronics Inc.
16530 Via Esprillo, San
Diego, CA 92127 USA
858-942-2230
caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms
or when unused for long periods of time.
14) Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
For the state of California, USA only
Perchlorate Material - special handling may
apply, See
www.dtsc.ca.gov/hazardouswaste/
perchlorate
For all other batteries, please view the section on
how to remove the battery from the product
safely. Hand the battery over to the applicable
collection point for the recycling of waste
batteries.
For more detailed information about recycling of
this product or battery, please contact your local
Civic Office, your household waste disposal service
or the shop where you purchased the product.
For customers in Canada
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation of the device.
High-power radars are allocated as primary users
(i.e. priority users) of the bands 5250-5350 MHz
and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN
devices.
Outdoor use of the 5 GHz Wi-Fi function is
prohibited by law.
Compliance with IC requirement RSS-210 A9.4.4
Data transmission is always initiated by software,
which is the passed down through the MAC,
through the digital and analog baseband, and
finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the
digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of
the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is
being transmitted. In other words, this device
automatically discontinues transmission in case of
either absence of information to transmit or
operational failure.
US
3
US

Publicidad

Tabla de contenido
loading

Tabla de contenido