UPDATE button
Indicates the status of the unit's software
update.
LINK indicator
Indicates the status of the network
connection of the unit.
VOL (volume) –/+ buttons
Tap to adjust the volume.
The / (on/standby) indicator and
reaction indicator flash according to the
volume adjustment when tapped.
/ (on/standby) button/indicator
Tap to turn the power of the unit on and
off.
Wi-Fi antenna
Set upright during Wi-Fi connection as
below.
Swing the left side of the antenna
outwards.
Pull out the antenna.
Rotate the antenna 90 degrees
clockwise.
Bring up the antenna.
N-Mark
If your smartphone is NFC-compatible,
touch the smartphone on the N-Mark.
The unit will turn on automatically and
registering (pairing) and BLUETOOTH
connection can be made.
AC IN terminal
Connect the AC power cord (supplied).
AUDIO IN jack
Connect to the headphone jack of a
portable audio device, etc., using a audio
cable (not supplied).
WPS button
Press and hold when connecting to a Wi-
Fi network.
Beeps will be heard by pressing and
holding the WPS button for 2 seconds,
which indicates that the unit is ready to
connect to a wireless router.
If your wireless router has a WPS button,
you can use this button to connect to the
network.
LAN port
Use a LAN cable (not supplied) to
connect the PC or the wireless router.
USB B port (
B)
Connect a PC using a USB cable (not
supplied).
When connecting a high-resolution
supported Walkman® or Xperia, use the
optional cable.
USB A port (
A)
Connect a USB flash drive directly. When
connecting to an iPhone/iPad/iPod or
Walkman®, use the cable supplied with
the device.
Remote sensor/Reaction indicator
When the unit receives signals from the
supplied remote control, the reaction
indicator (remote sensor) flashes.
Also, the indicator flashes according to
the volume adjustment of the unit.
To display the function buttons
Place your hand as illustrated below to
display the function buttons ( to ). To
display quickly, touch the center of the top
panel.
9
US