Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! Never switch on the Sander whilst the base is in contact with the workpiece or any other
surface as this may cause the operator to lose control over the tool and could result in serious injury.
CAUTION: Always hold the Sander securely by the SOFT GRIP SURFACE (2).
Connect the Sander to the mains power supply. To start the tool, press the ON/OFF SWITCH (1) to the
ON position.
To stop the tool, press the ON/OFF SWITCH (1) to the OFF position.
WARNING! Always wait until the tool has stopped vibrating completely before putting it down. Always
disconnect from the power supply after use.
CLEANING/EMPTYING DUST BOX
To maintain performance of the Sander the DUST COLLECTION BOX (9) and Filter will need cleaning
regularly.
To access the filter, pull the top part of the DUST COLLECTION BOX AWAY from the bottom.
Rinse the bottom half under clean running water and dry thoroughly.
Wipe the top half with a clean damp cloth and use compressed air to clean the integrated fabric filter.
To re assemble align the two halves and press the sections together, they will snap together when
correctly assembled.
Ensure both parts are completely dry before re-assembling, do not use if not completely dry.
NOTE: Ensure both parts click back together.
8
www.ELITETOOLS.co
Keep Working
Publicidad
