Publicidad
Idiomas disponibles
Idiomas disponibles
SANDING
WARNING! Always wear safety goggles, an adequate dust mask, hearing protection and suitable gloves
when working with this Sander.
IMPORTANT: Always use clamps to secure your workpiece to the workbench wherever possible.
WARNING! Do not use a sanding sheet on wood that has previously been used on metal. This may
cause scouring on the wooden surface. Do not use this Sander for sanding magnesium or for wet san-
ding.
CAUTION: Never touch a moving sanding sheet. Grip the Soft Grip Handle and switch on the Sander
using the ON/OFF SWITCH (1). Move the tool in a circular motion over the surface of the workpiece,
applying an even, moderate pressure until the desired surface is achieved.
NOTE Apply moderate pressure only. Excess pressure will not lead to a faster removal of material, but
will damage the sanding sheet and the tool.
If there are still scratches on your workpiece after sanding, try either of the following:
Return to a coarser grit sanding sheet and sand the marks out before recommencing with your original
choice of sanding sheet.
Use a new sanding sheet of the same grit to eliminate
the unwanted marks before progressing to a finer grit.
WARNING! Do not allow the sandpaper to wear down completely before replacing it. Failure to observe
this precautionary measure can lead to damage to base, resulting in sanding sheets failing to perform
properly.
CAUTION: Do not continue to use worn, torn, or heavily clogged sanding sheets. Ensure foreign objects,
such as nails and screws, are removed from the workpiece before commencing sanding.
9
www.ELITETOOLS.co
Keep Working
Publicidad
