Publicidad
Idiomas disponibles
Idiomas disponibles
DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and climate
controls. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Test the radio for
proper operation.
5. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
99-3527
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio
2. Secure the ISO brackets to the
radio with the screws supplied with
the radio. (Figure A)
3. Slide the radio into the radio
housing until the side clips engage.
(Figure B)
4. Snap the trim plate into the radio
housing. (Figure B)
5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and climate
controls. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Test the radio for
proper operation.
6. Reassemble the dash in reverse
order of disassembly.
3
(Figure A)
(Figure B)
Publicidad
