Quick Start Instructions - Neen PERICALM Manual De Instrucciones

Quick Start Instructions

1. Insert a 9 volt PP3 Alkaline battery into the battery compartment.
(Can also use a rechargeable Nickel Hydride battery (which has
a longer life than the Ni-Cad rechargeable batteries)
2. Insert lead wire/s to channel A, and B if both channels are to be used.
Note: only one channel is required if using PERIFORM
3. Attach lead wire/s to electrodes (vaginal, anal or surface electrodes).
4. Attach electrodes to correct body position. You should check with your
healthcare professional if you are in any doubt where to place electrodes.
5. Switch on the unit by pressing the Power button
6. Press the PRG (Program) button to select one of the programs
as detailed on page 11.
7. T o start press channel A+ and B+ button if you are using both channels
until you reach the comfortable intensity.
8. To stop the program, press the Power button which will turn the unit off.
Lock Button
A 'concealed' Lock button is included on the PERICALM™ which locks the
customised or built in programs. It also allows the clinician to accurately
monitor 'home compliance' of the patient between appointments.
To Lock the Unit
1. Select the pre-set or customised program required. In the case of
a customised program, make sure that the pulse width, frequency, time
etc. are set-up correctly.
2. Remove the battery cover and using a thin rod, gently press on the lock
button as shown in the diagram on page 8 until you hear a double beep.
The unit is now 'locked' and cannot be altered until 'unlocked'
To Unlock the Unit
Remove the battery cover and press the lock button with a thin rod until a
single beep is heard. Now the LCD will display the average mA used on each
channel and the total hours the unit has been in use as shown in the diagram.
To return to normal 'unlocked' operation, simply press PRG.
Hours Used
PERICALM™ Instruction Manual - GB
Channel A Channel B
9
+ or ANUFORM
®
.
®