Operating Instructions; Operation Of The 115 Volt Ac Outlets; Operation Of The Usb Charging Port; Reading The Dc Input Voltage And Output Power Indicators (Back Of Unit) - THOR PW Serie Manual Del Usario

OPERATING INSTRUCTIONS

CAUTION: Make sure the combined load requirement of your equipment does not exceed your inverter's
maximum continuous power.
Operation of the 120 Volt AC Outlets
This unit features four 115 volt AC GFCI (ground fault circuit interrupter) protected outlets, that function in the same
way as GFCI outlets you would typically use in your home. GFCI outlets are intended to protect equipment by
interrupting the circuit if current leakage exceeds 30 mA of current within 25 milliseconds.
1. Connect the inverter to a functioning 12 volt DC power source as described in this Instruction Manual. Make
sure there is adequate space for proper ventilation of the inverter.
2. Press the Power Pushbutton to turn the unit ON.
3. The Power/Fault LED display will light green, indicating a proper connection. If the Power/Fault LED Indicator
lights red, indicating a fault condition exists, refer to the "Troubleshooting" section of this Instruction Manual.
4. Plug the (110/120 volt AC) appliance into one of the Inverter's three-prong AC outlets and operate normally.
Note:
The Inverter will not operate appliances and equipment that generate heat, such as hair dryers, electric blankets,
microwave ovens and toasters.
Remember to disconnect the inverter from any power source when not in use.

Operation of the USB Charging Port

1. Connect the inverter to a functioning 12 volt DC power source as described in this Instruction Manual. Make
sure there is adequate space for proper ventilation of the inverter.
2. Press the Power Pushbutton to turn the unit ON.
3. The display will light up , indicating a proper connection. If the display, displays a fault code, indicating a fault
condition exists, refer to the "Troubleshooting" section of this Instruction Manual.
4. Plug the USB-powered device into the inverter's USB Charging Port and operate normally.
Note:
This unit's USB Charging Port does not support data communication. It only provides 2.1 Amps 5Volts DC power to an
external USB-powered device.
Remember to disconnect the inverter from any power source when not in use.

Notes on Using the Remote Control (sold separately)

The manufacturer offers (as a separate item) a Remote Control specifically designed for this line of inverters. The
inverter On/Off Switch must be in the off position when connecting the Remote Control to the unit, or the Remote
Control will not operate. Once the unit has been turned on using the Remote Control, inverter operation will continue
to be controlled through the Remote Control. Turn the inverter off before disconnecting the Remote Control. For more
information about attaching and using the Remote Control, please refer to the Remote Control Instruction Manual.
11