Garland Best 260 P Manual De Instrucciones página 28

Do not assemble any cutting disc if the other components have not been
assembled properly. Otherwise the disc can come off and it could hurt the user
or other people.
When working with the brushcutter use the front side of the machine (disc or
nylon head) below your waist level.
- 2 nylon heads:
Make sure that it has been assembled correctly and use it to reap, to cut the
grass, bad grass in the hedge or wherever there are trees, fences, walls or
stones.
In addition the nylon head reduces the possibility of damaging small plants and
the bark of the trees. Use exclusively flexible, non metallic nylon heads. Metallic
heads could break and it can be a dangerous projectile.
- Cutting disc:
Always make sure that it has been assembled correctly. When assembling the
cutting tools you should follow the instructions in the section "assembly the disc
and the nylon head". Adjust the cutting tools assembling all the pieces in the
right order.
With the disc, you can cut any kind of grass, hedges or small trees. Turn the
machine on like a scythe keeping the accelerator completely pressed.
WARNING: Always use a sharpened blade, worn out blades could produce
deficient results, and dangerous kickback of the machine could occur. As a
result, a dangerous kickback can occur, this could happen if the disc collides
with the trunk of a tree or against other solid objects and the user could lose
control of the machine.
Do not sharpen damaged blades, replace them with new blades.
WARNING: When using cutting disc, it is obligatory to use safety belts, double
harness type. Use original pieces and accessories. They can be acquired in the
authorized service distributors.
5. Fast release unit:
Pull off the hook handle belt and check that the hook is
released. Put the hook in the hook handle.
28