Other Functions; Adjusting The Balance And Fader; Quickly Attenuating The Sound; Cancelling The Beep Sound - Sony CDX-L490X Manual De Instrucciones

Other Functions

Adjusting the balance and
fader
You can adjust the balance and fader.
1
Press (SEL) repeatedly until "BAL" or
"FAD" appears.
Each time you press (SEL), the item changes
as follows:
LOW* t MID* t HI* t
BAL (left-right) t FAD (front-rear)
* When EQ3 is activated (page 12).
2
Press the volume +/– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT).
The "ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.

Cancelling the beep sound

Press (6) while pressing (SEL) down.
To activate the beep sound again, press these
buttons again.
Note
If you connect an optional power amplifier and do not
use the built-in amplifier, the beep sound will be
deactivated.
12

Setting the equalizer (EQ3)

You can select an equalizer curve for 7 music
types (XPLOD, VOCAL, CLUB, JAZZ, N-AGE,
ROCK, CUST, and OFF (equalizer OFF)).
You can store a different equalizer setting for
each source.
Selecting the equalizer curve
1
Press (SOURCE) to select a source
(Radio or CD).
2
Press (EQ3) repeatedly until the
desired equalizer curve.
Each time you press (EQ3), the item
changes.
To cancel the equalizing effect, select "OFF."
Adjusting the equalizer curve
You can store and adjust the equalizer settings
for different tone ranges.
1
Press (SOURCE) to select a source
(Radio or CD).
2
Press (EQ3) repeatedly to select the
desired equalizer curve.
3
Adjusting the equalizer curve.
1 Press (SEL) repeatedly to select the
desired tone range.
Each time you press (SEL), the tone range
changes.
LOW t MID t HI (t BAL t FAD)
2 Press the volume +/– button
repeatedly to adjust to the desired
volume level.
The volume level is adjustable by 1 dB
steps from –10 dB to +10 dB.
3 Repeat step 1 and 2 to adjust the
equalizer curve.
To restore the factory-set equalizer curve,
press (SEL) for 2 seconds.
After 3 seconds, the display returns to
normal play mode.
Note
When EQ3 is set to "OFF," you cannot adjust the
equalizer curve settings.