Descargar Imprimir esta página
Sony CDX-CA690X Manual De Instalación
Ocultar thumbs Ver también para CDX-CA690X:

Publicidad

Enlaces rápidos

FM/AM
Compact Disc
Player
Installation/Connections
Instalación/Conexiones
安裝 線路連接
CDX-CA690X
CDX-L570X
Sony Corporation © 2001
1
1
4
5
× 4
× 2
Equipment used in illustrations (not supplied)
Equipo utilizado en las ilustraciones (no suministrado)
插圖中的裝置(非附送)
Front speaker
Altavoces delanteros
前揚聲器
Rear speaker
Altavoces traseros
後揚聲器
Power amplifier
Amplificador de potencia
功率放大器
3-226-762-11 (1)
Printed in Korea
2
3
6
7
CD/MD changer
Cambiador de CD/MD
CD/MD 換碟機
Rotary commander RM-X4S
Mando rotativo RM-X4S
旋轉式控制器 RM-X4S
TV monitor
Monitor de TV
電視顯示器
2
A
CDX-CA690X only
Sólo CDX-CA690X
CDX-CA690X 為限
AUDIO OUT FRONT
AUDIO OUT REAR
B
CDX-CA690X only
Sólo CDX-CA690X
CDX-CA690X 為限
TV tuner unit*
Unidad de sintonización
de TV*
電視機調諧器*
Source selector*
Selector de fuente*
音源選擇器*
Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the wires under a screw, or caught
in moving parts (e.g. seat railing).
• Before making connections, disconnect the
earth terminal of the car battery to avoid short
circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all earth wires to a common earth
point.
• Be sure to insulate any loose unconnected
wires with electrical tape for safety.
Notes on the power supply cord (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
Connection example (2)
Notes (2-A)
• Be sure to connect the earth cord before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
Tip (2-B-
)
For connecting two or more changers, the source
selector XA-C30 (optional) is necessary.
(CDX-CA690X only)
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
BUS CONTROL IN
* not supplied
* no suministrado
* 非附送
Connection diagram (3)
1
To a metal surface of the car
First connect the black earth lead, then connect
the yellow and red power input leads.
2
To the power aerial control lead or power
supply lead of aerial booster amplifier
Notes
• It is not necessary to connect this lead if there
is no power aerial or aerial booster, or with a
manually-operated telescopic aerial.
• When your car has a built-in FM/AM aerial in
the rear/side glass, see "Notes on the control
and power supply leads."
3
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
4
To the interface cable of a car telephone
5
To the +12 V power terminal which is energised
in the accessory position of the ignition key
switch
Notes
• If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energised at all times.
Be sure to connect the black earth lead to it
first.
• When your car has a built-in FM/AM aerial in
the rear/side glass, see "Notes on the control
and power supply leads."
6
To the +12 V power terminal which is energised
at all times
Be sure to connect the black earth lead to it first.
Notes on the control and power supply leads
• The power aerial control lead (blue) supplies +12 V
DC when you turn on the tuner.
• When your car has built-in FM/AM aerial in the
rear/side glass, connect the power aerial control
lead (blue) or the accessory power input lead (red)
to the power terminal of the existing aerial
booster. For details, consult your dealer.
• A power aerial without relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected,
power will always be supplied to the memory circuit
even when the ignition key is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid its damage.
• Do not connect the speaker terminals to the car
chassis, or connect the terminals of the right
speakers with those of the left speaker.
• Do not connect the earth lead of this unit to the
negative (-) terminal of the car.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active
speakers (with built-in amplifiers) to the speaker
terminals may damage the unit.

Publicidad

loading

Resumen de contenidos para Sony CDX-CA690X

  • Página 1 Selector de fuente* 音源選擇器* CDX-L570X * not supplied * no suministrado * 非附送 Sony Corporation © 2001 Printed in Korea Cautions Connection diagram (3) • This unit is designed for negative earth 12 V To a metal surface of the car First connect the black earth lead, then connect DC operation only.
  • Página 2 若要連接 2 臺或 2 臺以上換碟機時,必須使用音源選擇 a masa antes de realizar la conexión al Notas sobre la conexión de los altavoces • 請僅連接無源揚聲器。若將有源揚聲器(帶內置放大 器 XA-C30(選購件)。(CDX-CA690X 為限) amplificador. • Antes de conectar los altavoces, desconecte la 器)連接到揚聲器端子上會損壞本機。 • Si conecta un amplificador de potencia opcional y alimentación de la unidad.
  • Página 3 Japanese cars. In such a case, consult Usted no podrá instalar esta unidad en algunos fin de abrirlo, después deslícelo hacia la derecha, your Sony dealer. automóviles japoneses. En tal caso, consulte a su 4-B To attach y por último tire de su parte izquierda.
  • Página 4 4-A 拆卸 拆卸前面板之前,須先按下 (OFF) 鍵。 然後,按下 (OPEN) 鍵以便開啟前面板,將 前面板稍微向右邊滑動,然後從前面板的左側拉出。 將本機安裝於日本產汽車上時 4-B 裝配 (6) 如圖所示,將前板的 孔搭在本機的支軸 有的日本產汽車不能安裝本機,在這種情形下,請 上,然後推入左側。 您向當地的 Sony 經銷商諮詢。 註 為防止發生故障,安裝時只能使用附送的螺絲 4 。 頻率選擇開關 AM(FM)調諧間隔在出廠前被設定在 10 k (200 k)位置上。若貴國的頻率分配系統是以 安裝在點火鑰匙開關上沒有 ACC 9 kHz(50 kHz)間隔為基礎的,連接前,請將本 (輔助)位置的汽車上時的警告 機底部上的開關設定在 9 k(50 k)位置上。 在關掉汽車引擎之後,一定請按下機器上的...

Este manual también es adecuado para:

Cdx-l570x