Code Identification; Reset To Factory Settings - Philips SRP9232D/27 Manual De Instrucciones

Using Your Remote

Code Identification

1. Press and hold down the SETUP
2. Press and release the desired
3. Press and release the
4. Press and release the #1 button.
5. Press and release the ENTER
Reset to Factory
1. Press and hold down the SETUP
2. Press and release the
3. Press and release the number #0
button on the remote until the
red light on the remote control
turns on. Release the SETUP
button. The red light will
remain on.
device button (TV, STRM, AUD)
you would like the code for.
ENTER button.
Count the number of times the
remote light flashes. This is the
number corresponding to the
first digit of the code. Repeat
the process by pressing the
#2, #3 and #4 buttons for the
remaining digits.
button to exit this mode.
Settings
button on the remote until the
red light on the remote control
turns on. Release the SETUP
button. The red light will
remain on.
MUTE button.
button. The red indicator light will
flash twice.
11