Igniting The Grill - Weber Genesis II E-310 Manual Del Propietário

Igniting the Grill

Using the Electronic Ignition System to
Ignite the Grill
Each control knob operates an individual burner, and
each burner ignites independently. Ignite the burners
starting from left to right. All burners should be lit for
preheating, however, all burners do not have to be lit
while grilling.
1) Open the grill lid (A).
2) Check that all burner control knobs are in the off
position. Check by pushing in and turning knobs
clockwise (B).
3) Turn the gas supply valve on (C).
4) Begin with the burner furthest to the left. Push the
burner control knob in and turn it counterclockwise
to the start/high position (D).
5) Push and hold the electronic ignition button (E).
You will hear it ticking.
6) Check that the burner is lit by looking through the
cooking grates and through the half-circle cutout in
the FLAVORIZER BARS.
7) If the burner does not ignite, turn burner control
knob to the off position and wait five minutes to
allow the gas to clear before attempting to light the
burner again.
8) If the burner ignites, repeat steps 4 through 6 to
light the remaining burners.
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section.
There you will find instructions on igniting the grill
with a match to help determine the exact problem.
To Extinguish Burners
1) Push each burner control knob in and then turn
clockwise all the way to the off
2) Turn gas supply valve off.
B
A
position.
B
C
A
E
D
C
D
E
WARNING: Open lid during ignition.
m
WARNING: Do not lean over open grill while
m
igniting or cooking.
WARNING: Each burner must be ignited
m
individually by pushing the electronic ignition
button.
WARNING: If ignition does not occur within
m
four seconds of attempting to light the first
burner, turn the burner control knob to
the off position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
13