Maintaining The Grill Light; Annual Maintenance - Weber SUMMIT S-660 Guia Del Propietario

ANNUAL MAINTENANCE

Inspection and Cleaning of the Spider/Insect Screens
To inspect the spider/insect screens, remove the control panel. If there is dust or dirt on
the screens, remove the burners to clean the screens.
Brush the spider/insect screens lightly with a soft bristle brush (i.e., an old toothbrush).
m CAUTION: Do not clean the spider/insect screens with hard
or sharp tools. Do not dislodge the spider/insect screens or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube. Once the spider/
insect screens and burners are clean, replace the burner.
If a spider/insect screen becomes damaged or cannot be cleaned, please contact the
Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com.
Burner Flame Pattern
The Weber gas grill burners have been factory set for the correct air and gas mixture.
®
The correct flame pattern is shown in illustration and described below:
A) Burner tube (1)
B) Tips occasionally flicker yellow (2)
C) Light blue (3)
D) Dark blue (4)
If the flames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures.
◆

MAINTAINING THE GRILL LIGHT

• When installing three new AAA batteries (alkaline only), confirm that each battery's
plastic wrapping has been removed. Do not confuse this plastic with the battery label.
• Do not mix old and new batteries or different types of batteries (standard, alkaline or
rechargeable).
• Verify that the batteries are in good condition and have been installed correctly.
• If you do not plan to use the light for a month or more, remove the batteries.
• Wipe the light clean with a damp cloth only. Do not use alcohol-based or abrasive
cleaners.
• The light is weather resistant to rain and snow, but not waterproof. Do not submerge
in water / liquids.
• Light is heat resistant. Grease fires or running the grill on high for an excessive
amount of time can damage internal components.
Press the AWAKE button to activate the grill light. The light has a 'tilt sensor' that will
turn on the light if the grill lid is opened and turn off the light when the grill lid is closed.
If the lid is left open or closed for more than 30 minutes, the grill light will deactivate. To
turn the light back on, press the AWAKE button (5).
NOTE: The light does not turn OFF by pressing the AWAKE button.
32
MAINTENANCE
◆
1
5
2
3
4