Daily Use - Drying - AEG LAVAMAT 61270 WDBI Manual De Instrucciones

18 www.aeg.com
The water must be emptied out before
opening the door. During this time the
drum continues to turn at regular inter-
vals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
• Set the DRAIN or SPIN programme
• Reduce the spin speed, if needed
• Press the button 8
• When the programme has finished the
display shows a blinking
light C goes off. The door can be
opened.

10. DAILY USE - DRYING

10.1 Drying only
The recommended load size is 3 kg for
cottons and linen, and 2 kg for synthetic
items.
It is also possible to dry up to 4
kg of cotton items (see the «Dry-
ing Programme » table).
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of
laundry in order to obtain the best
drying performances.
3. Set the drying programme for Cot-
tons or Synthetic in the Drying sec-
tor of the programme dial.
4. Press button 6 to set the drying
time. Press this button again and
again until the time you want ap-
pears on the display.
For Cottons you can set a drying
time from 10 minutes to 250 minutes
(hours 4.10).
For Synthetic you can select a drying
time from 10 minutes to 130 minutes
(hours 2.10).
Every time you press this button the
drying time increases by 5 minutes.
Turn the programme selector dial to
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Stand by : once the programme has fin-
ished after a few minutes the energy sav-
ing system will be enabled. The bright-
ness of the display is reduced. By press-
ing any button the appliance will come
out of the energy saving status.
. The pilot
5.
6.
Note! The programme time will au-
tomatically increase by a few mi-
nutes.
Press button 8 to start the pro-
gramme.
After the programme has started,
the time remaining is updated every
minute.
If you set only 10 minutes of dry-
ing phase with the timed drying
button, the appliance performs
only a cooling phase.
At the end of the drying pro-
gramme, some acoustic signals
sound. A blinking
display.
The pilot light B, and C and the light
of the button 8 go off.
At this point, begins an anti-crease
phase, which lasts for about 10 mi-
nutes. During this time the light C is
on. The door cannot be opened.
appears on the