Basic Playback - Pioneer VSX-1024-K Guia De Inicio Rapido

Basic playback

Multichannel playback
STANDBY/ON
SLEEP SOURCE
RECEIVER SIGNAL SEL
CTRL S.SEL ECO INPUT
BD GAME HDMI
CH
CBL ROKU
DVD SAT MHL
USB ADPT
iPod CD BT
VOL
TUNER
TUN TV NET
LISTENING MODE MUTE
AUTO SURR ADV
AUDIO P.
TOOLS
TOP
MENU
MENU
ENTER
RETURN
HOME
MENU
BAND PTY
Fav
PRESET TUNE
POP UP SUB TITLE DISP AUDIO
CLR
CH LEVEL
SB CH CH SEL
BASS BASS TRE TRE
SHIFT
DIMMER STATUS
SP-A/B
RECEIVER
1
Switch on the playback component.
E.g. Turn the Blu-ray Disc player connected to the
HDMI BD IN terminal on.
2
Switch the input of the receiver.
E.g. Press BD to select the BD input.
3
Press AUTO to select 'AUTO SURROUND'.
Also press SURR or ADV for multichannel playback. Select
your preferred listening mode.
4
Start the playback component's playback.
2
E.g. Start playback of the Blu-ray Disc player.
5
Use VOLUME +/– to adjust the volume level.
• If no sound comes out of the center speaker or surround
3
speaker, change the listening mode by pressing SURR or
ADV.
E.g. Repeatedly press ADV to select [EXT.STEREO].
• If there is no sound from the subwoofer
5
Cause:
The front speaker is set to LARGE.
(During 2ch audio input, the low frequency sound is
output not from the subwoofer but the front speaker)
How to fix:
If you want the sound to come from the subwoofer, please
change the speaker setup. (There are 2 following methods)
Method 1:
Change the front speaker to SMALL.
The low frequency sound will be output not from the front
speaker but the subwoofer.
We recommend not changing this if the low frequency
function of the front speaker is high.
Method 2:
Change the subwoofer to PLUS.
The low frequency sound will output from both the front
speaker and the subwoofer.
This may lead to excessive low frequency sound.
If that happens, we suggest you do not change the setting
or change to Method 1.
l "Speaker Setting" on page 53.
Note
• If not using the remote control to operate:
– When operating the receiver, press RECEIVER CTRL and
then operate.
– When operating devices such as NETWORK, TUNER,
and iPod, press the various function button (NET, TUNER,
iPod USB, etc.) before operating.
• In order to listen to the audio from the source component
that is connected to this receiver using a coaxial or an
optical cable, choose the C1 (coaxial) or O1 (optical) input.
(Press SIGNAL SEL.)
5