Hansgrohe Rainmaker Select 460 2jet 2401540 Serie Instrucciones De Montaje página 4

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
The shower may only be used for bathing, hygiene
and body cleaning purposes.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The product is not designed to be used with steam
baths!
Technical Data
Operating pressure:
Recommended operating pressure:
Hot water temperature:
Thermal disinfection:
This mixer cannot be used in conjunction with hydrauli-
cally, electronically or thermally controlled instantane-
ous heaters.
The product is exclusively designed for drinking water!
Fault
Head shower extremely leaky
4
max. 0,6 MPa
0,3 - 0,4 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
max. 70°C / 4 min
Cause
- Head shower soiled / scaled
Assembly (see page 36)
English
Symbol description
for cold water
Warm water
The wall must be reinforced in this area.
Plug the unused outlet.
Waste
Raindrain
Do not use silicone containing acetic acid!
Dimensions (see page 37)
Flow diagram (see page 32)
Spare parts (see page 42)
Special accessories
order as an extra
extension 25 mm (see page 42)
levelling set 1° (see page 42)
Cleaning (see page 38)
i Installation example (see page 32)
Remedy
- Clean / descale head shower see
page 38