Epson ELPIF03 Manual De Usuario página 99

FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions : (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING
The connection of a non-shielded equipment interface cable to this equipment
will invalidate the FCC Certi cation or Declaration of this device and may cause
interference levels which exceed the limits established by the FCC for this equipment.
It is the responsibility of the user to obtain and use a shielded equipment interface
cable with this device. If this equipment has more than one interface connector,
do not leave cables connected to unused interfaces. Changes or modi cations not
expressly approved by the manufacturer could void the user's authority to operate the
equipment.
For Canadian Users
99